Original Roland MDX-540A / MDX-650A ATC Tool Holder 15T-NDC10-52-PB for ZAT-540 / ZAT-650

The 15T-NDC10-52-PB is an ATC tool holder for the Roland ZAT-540 and ZAT-650 automatic tool changers, used on the MDX-540A, MDX-540SA and MDX-650A benchtop subtractive rapid prototyping machines. Each holder carries one cutting tool so that the machine can pick it up and change tools automatically during a job. This is a genuine, original Roland part – not a copy or compatible replacement.

Extra tool holders let you prepare more tools in advance and run longer, more complex jobs without stopping. A replacement is also needed when a holder has been damaged in a crash, has a worn taper or collet seat, or causes runout and poor finish. Damaged holders can lead to tool-change errors and dropped tools, so they should be replaced promptly.

Key features

• Genuine original Roland part
• ATC tool holder 15T-NDC10-52-PB
• For ZAT-540 and ZAT-650 automatic tool changers
• Lets you load more tools for automatic changing
• Precise seating for accurate, repeatable tool length

Compatible models: Roland MDX-540A, MDX-540SA and MDX-650A.

Note: This tool holder is only for machines equipped with the ATC. It cannot be used on machines without an ATC installed.

Please check the part number on your existing part, or contact us with your machine model and serial number if you are not sure about compatibility.