Original Roland ZHS-300 End Mill 3 mm, 6 mm Shank for MDX-540 / MDX-50 / MDX-40A

The Roland ZHS-300 is a two-flute end mill designed for Roland MDX series milling machines. It has a 3 mm cutting diameter, a 10 mm flute length, a 6 mm shank and an overall length of 50 mm, making it a versatile tool for roughing and finishing small models and prototypes. This is a genuine, original Roland part – not a copy or compatible replacement.

The 3 mm diameter is a good balance between detail and material removal, so this end mill is often used for modeling wax, chemical wood, resins and plastics. Replace your end mill when cutting edges are chipped or dull, the surface finish turns rough or melted, the spindle load increases, or you hear chattering during cuts. A sharp tool also reduces stress on the spindle and collet.

Key features

• Genuine original Roland part
• Two-flute end mill, 3 mm cutting diameter
• 6 mm shank, 10 mm flute length, 50 mm overall length
• Suitable for modeling materials, resins and plastics
• For roughing and finishing on MDX milling machines

Compatible models: Roland MDX-50, MDX-540, MDX-40A, MDX-500, MDX-650 and EGX-350 (with a 6 mm collet).

Please check the part number on your existing part, or contact us with your machine model and serial number if you are not sure about compatibility.